Making Hardwood Flooring Splines

Prefinished hardwood floors is it ok to spline in the middle of the room.

Making hardwood flooring splines.

When laying hardwood floors the need to reverse the direction of the tongue always comes up. Hardwood floor spline is used for a transition piece in tongue and groove flooring when changing the direction of the hardwood floor. Im doing it this way because it is an insurance job and i need to fit around fire place trim. But now imagine putting a lot of stress on a miter joint assembled with a thin long grain spline.

The best way to make a hardwood spline is shown in the drawings at right. Can i buy a standard 1 4 inch one and then hand plane power plane sand it down. Weather it s the new generation on laminate floors traditional hardwoods or hardwood floors that you have taken from the woods and made yourself they will add value to your home. Hie spline would likely split along the grain and the joint would come apart.

Our hardwood floor spline sliptongue is made from domestic hardwoods. The easiest way to make a hardwood spline is to simply rip a thin strip from a board. I was wondering if it is ok to start in the middle of a room and spline back the other direction after one side is done. 36 â sold individually or by the pack.

Thanks a ton for your expert advice guyz. Our sliptongue is produced using either red oak or poplar depending on availability. Hardwood floors add warmth and beauty to your home. While in the first room the grooves on each plank might point away from the door a transition allows that direction to change and the grooves to point the.

With the proper tools and a bit of hard work you can make your own. The tongue is like 225 and not the normal 1 4 inch and the manufacturer does not sell splines slip tongue. How do i make my own spline. A change in direction refers to the positioning of the tongue and groove joints between each adjacent plank.